5v 4 pin fan pinout3/9/2023 Other wise it hangs sometimes when booting, due to overshoots. To get safe startup, set the output voltage only to 1.5V. ![]() (IC/location of the limiter must be found). At higher voltages, the overvoltage limiter kicks in. Now you can adjust the output voltage with the top right potentiometer to max 13.62V. Modification: Change 9K09 resistor (on the right of the three potentiometers) on the piggyback controller board to 10k. He found a way to modify the HP DPS-460EB A (see below) to output 13.5V instead of 12V. They have to be shorter, because if the power supply is hot plugged, they should connect last after all other pins are already connected.ĮDIT (): By courtesy of JP Peiffer (Belgium) The power-on pins are often the shorter pins. The other unknown pins could be SPI or I2C for handling status information of the power supply or to regulate the cooling fan speed. ![]() On the following pictures you see the power supply and their pinout.Īt the moment there are only the power and power-on pins known. I removed the power supplies and reverse engineered the pinout of them. ![]() Last week I found some rack server with hot swap power supply. While dumpster diving the electronic scrap I find always interesting parts.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |